You need these software’s/ settings to see the data in PC for this Industrial parameters monitoring over PC with wireless pre-requirements project.
step 1.
you need to install any serial monitor software (we recommend to use arduino software)
download link .
step 2
you need install cp2102 drivers in laptop.
after installing the both softwares in laptop open arduino software select the com port in tools.
next you need open the serial monitor in arduino software and make the following changes for 1st time.
select NL and NC and baud rate 9600.
next switch on the transmitter unit you will the date .
NOTE : – IF Receiver module is unpluged then again you need to open the serial monitor in arduino software freshly else you not be able to see the data.