Water Scheduling for Municipalities Using RTC

The main aim of this student project is to build a Water Scheduling for Municipalities using RTC.

Project Scope:

In main cities the water distribution system was done in regional manner. Normally the municipalities are responsible for this water distribution.

It can be done through manually, but it can’t possible to maintain scheduling for all times. Time lagging is reduced by this system arrangement. So, we go for this real time scheduling of water supply.

In this project we have a RTC (real time clock). We should provide water supply in particular area with in a periodic time interval. This time interval is set in a RTC programming.

These all operations are controlled by the micro controller. The Water scheduling time may be edited by modifying the RTC programming.

Software’s used to develop this project:

  • 1) Keil c
  • 2) Orcad/Express PCB.

Hardware components requirements:

  • 1) Micro controller.
  • 2) RTC
  • 3) Relay
  • 4) Motor
  • 5) Power supply

Block Diagram:

2 Replies to “Water Scheduling for Municipalities Using RTC”

Leave a Reply

Your email address will not be published. Required fields are marked *